ELANTAS PDG CONATHANE EN-4 Polyurethane Encapsulant Part A 1 gal Can

Part number: EN-4 PART A GAL
ELANTAS PDG CONATHANE EN-4 Polyurethane Encapsulant Part A 1 gal Can

For current pricing and to place an order please contact your Ellsworth Customer Service Representative.

Call Us

Call Us
Contact customer service at 877-454-9224.

Email Us

Email Us
Email us for product availability.

 

ELANTAS PDG CONATHANE EN-4 Polyurethane Resin System is a two component, non-MBOCA system that is used for molding and potting electrical assemblies that are exposed to extreme thermal changes. It is typically used for print circuit boards, electrical cables, connectors, strain sensitive devices, and wire wound devices. It offers good dielectric properties, hydrolytic stability, low viscosity, high elongation, and resistance to fungus and thermal shock. Part A, 1 gal Can. 

Must purchase the EN-7 PART B GAL Polyurethane Encapsulant separately, see below. Mix Ratio by weight is 100/17.5 Part A to Part B.

<p>ELANTAS PDG&nbsp;CONATHANE EN-4 Polyurethane Resin System is a two component, non-MBOCA system that is used for molding and potting electrical assemblies that are exposed to extreme thermal changes. It is typically used for print circuit boards, electrical cables, connectors, strain sensitive devices, and wire wound devices. It offers good dielectric properties, hydrolytic stability, low viscosity, high elongation, and resistance to fungus and thermal shock. Part A, 1 gal Can.&nbsp;</p> <p><span style="color: #ff0000;">Must purchase the EN-7 PART B GAL Polyurethane Encapsulant separately, see below. Mix Ratio by weight is 100/17.5 Part A to Part B.</span></p>
Typical Use: Recommended for use as a molding and potting compound for general electronic use. Especially suited for the protections of delicate electronic/electrical devices that must perform in hostile environments, especially underwater sound devices.
Brand: CONATHANE
Chemical Composition: Urethane
Color: Amber
Components: 2 part
Cure System: Room Temperature/Heat
Cure Time: EN-7: 10 to 14d @ 25 °C; 4 to 6h @ 100 °C; EN-8: 5 to 7d @ 25 °C; 1h @ 100 °C
Dielectric Strength: 785 V/m
Elongation: >400%
Flash Point: >93 °C
Hardness: 90 A
Mix Ratio: 100:17.5
Specific Gravity: Part A: 0.97 @ 25 °C; Mixed: 1.01 @ 25 °C
Tensile Strength: >2,000 psi
Viscosity: 9,000 @ 25 °C
Volume Resistivity: >4.3 x 10^15 ohm-cm

 

This site uses cookies

We use cookies to provide you with the best possible experience. By using this site, you accept our terms of service and use of cookies.